Two batches has been prepared involve calcium carbonate- zirconia and dolomite- zirconia with mole ratio 1:1. After mixing in water and drying, samples were preesed in cylinder form and then fired at four temperatures for three hours. The phase evaluation was studied by XRD technique. Calcium zirconate were established at all samples. At 1300 ˚c monoclinic zirconia phase was observed that its intensity is more in dolomite samples. With increasing temperature the intensity of ZrO2 phase is decreased and stabilized zirconia with calcia (Ca0.15Zr0.85O1.85 ) is observed.
Ianoş,R., Barvinschi,P., "Solution combustion synthesis of calcium zirconate, CaZrO3, powders", Journalof Solid State Chemistry,Vol.183 (3), pp 491-496, (2010).
Rog, G ., Dudek, M., Kozłowska-Rog, A., Bućko,M., "Calcium zirconate: preparation, properties and application to the solid oxide galvanic cells", ElectrochimicaActa, Vol.47 (28), pp 4523-4529, (2002).
Serena, S., Sainz,M. A., de Aza, S., Caballero, A., "Thermodynamic assessment of the system ZrO2-CaO-MgO using new experimental results", Journal of the European ceramic Society, Vol. 25, pp 681-693, (2005).
Prasanth, C. S., Padma, Kumar, H., Razhani, R.," Synthesis, Characterization and microwave dielectric properties of nanocrystalline CaZrO3 ceramics", Journal of alloysand compounds, Vol. 464, pp 306-309, (2008).
Saavedra, M.J., Parada, C., "Ca-Zr-O system: Synthesis and characterization of compound using several routes of preparation", Solid state lonics, Vol. 63-65, pp. 213-217, (1993).
Szczerba, J., pedzich, Z., "The effect of natural dolomite admixtures on calcium zirconate-periclase materials microstructure evolution", Ceramic International, Vol. 36, pp. 535-547, (2010).
Li, Z., Lee, W. E ., "Low-temperature synthesis of CaZrO3 powder from molten salts", J. Am. Ceram. Soc. Vol. 90 (2), pp364-368, (2007).
Le, J., Van Rij, L. N., Landschoot, V., Schoonman, J., "A wet-chemical method for the synthesis of In-doped CaZrO3 ceramic powders", Journal of the European Ceramic Society, Vol. 19,pp 2589-2591, (1999).
Lanos, R., Barvinschi, P., "Solution combustion synthesis of calcium zirconate, CaZrO3, powders", Journal of solid state chemistry, Vol 183,pp 491-496, (2010).
Li, M., Gehre, P., Anezeris, C. G., "Investigation of calcium zirconate ceramic synthesis by slip casting and calcinations", Journal of the European Ceramic Society, Vol. 33, pp. 2007-2012, (2013).
Pollet, M., Marinel, S., Desgardin, G., "CaZrO3, a Ni-C-Co- sinterable dielectric material for base metal-multilayer ceramic capacitor applications", Journal of European Ceramic Society, Vol. 24, pp. 119-127, (2004).
Han, J., Wen, Z., Zhang, J., Gu, Z., Xu, X., "Fabrication of dense CaZr0.9In0.1O3-δ ceramics from the fine powders prepared by an optimized solid-state nucleation method", Solid-State Ionics, Vol. 119, pp.1108-1111, (2008).
Rodriguez, J. L., Rodriguez, M. A., De Aza, S., Pena, P., "Reaction sintering of zircon-dolomite mixtures", Journal of the European Ceramic Society, Vol. 21, pp. 343-354, (2001).
امین. محمد حسن، حکمی. محمد، صولتی. مهران و کاوه ارزانی،" بررسی تاثیر افزودنی کلینکر زیرکونات کلسیم بر تحولات فازی و ریزساختار دیرگدازهای منیزیایی،" چهارمین کنگره سرامیک ایران، (1381).
Rezaei, A., Naghizadeh, R., & Rezaie, H. R. (2016). Synthesis Calcium Zirconate with Ceramic Method. Journal Of Metallurgical and Materials Engineering, 27(1), 1-10. doi: 10.22067/ma.v27i1.19952
MLA
Alireza Rezaei; Rahim Naghizadeh; Hamid Reza Rezaie. "Synthesis Calcium Zirconate with Ceramic Method", Journal Of Metallurgical and Materials Engineering, 27, 1, 2016, 1-10. doi: 10.22067/ma.v27i1.19952
HARVARD
Rezaei, A., Naghizadeh, R., Rezaie, H. R. (2016). 'Synthesis Calcium Zirconate with Ceramic Method', Journal Of Metallurgical and Materials Engineering, 27(1), pp. 1-10. doi: 10.22067/ma.v27i1.19952
VANCOUVER
Rezaei, A., Naghizadeh, R., Rezaie, H. R. Synthesis Calcium Zirconate with Ceramic Method. Journal Of Metallurgical and Materials Engineering, 2016; 27(1): 1-10. doi: 10.22067/ma.v27i1.19952
Send comment about this article